Factory receiver and tube bumper
#1
Registered User
Thread Starter
iTrader: (1)
Join Date: Mar 2010
Location: Tucson, AZ
Posts: 239
Likes: 0
Received 0 Likes
on
0 Posts
Factory receiver and tube bumper
anyone ever fab up a tube bumper based off of the receiver? Stared at the ass end of my runner today trying to figure out how to design it and how it would look. any ideas?
#2
Registered User
no, because it'd be impractical in a serious wheeler..
darn thing would drag like a fat chick riding the gravitron at the fair. throw the whole dang thing out of balance
darn thing would drag like a fat chick riding the gravitron at the fair. throw the whole dang thing out of balance
#4
Registered User
Join Date: Apr 2008
Location: Vermont
Posts: 238
Likes: 0
Received 0 Likes
on
0 Posts
I have a truck but similar situation in that the stock channels that the oe bumper mount on are way too low. I fabbed a 3x6 tube with a step and flared ends and welded to those channels but mutch higher and used gussets to transfer potential load. However it blocks my plate and I get pulled over because of these every so often.
#6
Love the philmont sticker! I just got myself a 94 runner that my dad put plenty philmont stickers on. I was looking at the hitch on it also and figured the same thing others said, it would be low and scrape like said fat chick on gravitron (very odd mental image going on now....)
#7
Thread
Thread Starter
Forum
Replies
Last Post
malteserunner
Early Land Cruisers (Build-Up Section)
89
02-09-2018 06:59 AM
r3dfish
86-95 Trucks & 4Runners (Build-Up Section)
54
05-16-2016 10:31 PM
justdifferentials
Just Differentials
1
09-17-2015 06:14 PM
priest16
84-85 Trucks & 4Runners (Build-Up Section)
15
08-06-2015 07:43 AM