Greetings,
First off...long time lurker on the site, first time poster, so I will appologize up front if I put this in the wrong forum. I have a 89 4runner that I have dreams of turning into something of a pre runner. I will eventually be installing a LT up front, and was looking to drop a rear t-100 axle out back to match the track width. My question is this:While I have found plenty of fenders, does anyone make 1st generation 4runner fiberglass bedsides? I will need something to cover the tires here in CA. Im really just in a planning stage right now, but I will post pics whenever I get started on the builld. Any help and/or ideas would be appreciated.

 

I can tell you they exist because I had them on two of my 4runners, a 89 and a 88.

I think there was a place in BC (Canada) that sold them.

This might be the place but I have no idea really, there were already on my 4runners when I bought them:

http://toyotafiberglass.com/

 

^ Those are the guys. I have seen several 86-89 4runners around here with full fiberglass kits from them. I believe they are pricey, and I only heard of trucks being dropped off to get serviced... but they must ship as well.

 

We have lots of pieces for the 4Runner including 3 types of 1/4r panels - stock - 3" flared - hi clearance , all with fronts to match

http://www.toyotafiberglass.com/4Runner.htm

ALWAYS , very busy , dont wait till you need them to get in line , or you'll be dissapointed usually booking 2-3 months in advance

also check out the vendor section on this board , we have a few "builds" you can have a look at
.

 

slackers panels are great, i've had them on my truck since 04'... they are SOLID.... and good quality. Rolled my truck and the panels popped out when i was flipped over, a lick of paint and they were like brand new.