Tube benders
Jun 30, 2009 | 04:38 PM
#21
Registered User
Joined: Jun 2009
Posts: 1
Likes: 0
I build bumpers for the FJC. I use the JD2 with an air over hydro cylinder. $100.00 for the ram and $ 89.00 for the mount kit from Copperhead Farbrication.
I've used this thing manually a great deal and can tell you that going to the air over Hydro makes a HUGE difference. I bend multiple bumpers at a time with this set up and it goes all day long. I also use the tube notcher pictured in post #19.
Trust me, if you bend up a couple rigs worth of cages, sliders and bumpers you are going to have people coming to you to get stuff bent. It'll pay that bender off in a heart beat.
I've used this thing manually a great deal and can tell you that going to the air over Hydro makes a HUGE difference. I bend multiple bumpers at a time with this set up and it goes all day long. I also use the tube notcher pictured in post #19.
Trust me, if you bend up a couple rigs worth of cages, sliders and bumpers you are going to have people coming to you to get stuff bent. It'll pay that bender off in a heart beat.
Jun 12, 2010 | 11:35 AM
#22
Registered User
Joined: May 2010
Posts: 4
Likes: 0
tube benders
Take a look at our site www.pro-tools.com I will give 10% off for being on this forum.
Thank-you
Mike
Thank-you
Mike
Thread
Thread Starter
Forum
Replies
Last Post
TheBFA
Solid Axle Swaps, All Years
8
Feb 15, 2020 06:55 AM
