84Horunner

I've installed Longfields on my 84 4Runner. I'm trying to put the hubs back on and i've got them on, now the hub dial wont go far enough to get the snap ring into the groove on the axle shafts.

Anyone had this problem before?

waskillywabbit

iTrader: (-1)

Pull the axle out a little with some channel locks or something.

Tofer

i also use the 12mm gold saftey washer/bolt and a screw drive to pull the shaft out as i push the snap ring in

84Horunner

So its pushed in a little? I'll try the channel locks or something to pull it out. All i need is about 1/2 an inch or so.