YotaTech Forums
save these...
save these...
0 2019/10/06 10:18:00
use a brass hammer and impact the flat spot on the linkage to jar it loose.
use a brass hammer and impact the flat spot on the linkage to jar it loose.
0 2019/10/06 10:18:06
apply the pitman arm puller, put some tension on it, and give it a few wacks with your hammer to break it free
apply the pitman arm puller, put some tension on it, and give it a few wacks with your hammer to break it free
0 2019/10/06 10:18:13
all better. torque spec is 130 foot pounds.
all better. torque spec is 130 foot pounds.
0 2019/10/06 10:18:20
0 2019/10/06 10:29:21
0 2019/10/06 10:29:26
in case your wondering, the little fin cut up front is because the prototype truck had tires too big and rubbed the guards. may replace later but doesnt bother me now.
in case your wondering, the little fin cut up front is because the prototype truck had tires too big and rubbed the guards. may replace later but doesnt bother me now.
0 2019/10/06 10:29:33
splashes beware, im guarded.
splashes beware, im guarded.
0 2019/10/06 10:29:41
0 2019/10/20 08:35:22
0 2019/10/20 08:35:25
Part number for you
Part number for you
0 2019/10/26 09:38:45
Strap wrench and deep well 14mm
Strap wrench and deep well 14mm
0 2019/10/26 09:38:51
Driver side view
Driver side view
0 2019/10/26 09:38:55
Full underview with 4 new stops.
Full underview with 4 new stops.
0 2019/10/26 09:38:59
0 2019/11/04 13:16:14
0 2019/11/04 13:16:19
0 2019/11/13 14:05:47
0 2019/11/13 14:06:34
0 2019/11/13 14:06:40
0 2019/11/13 14:06:48
0 2019/11/13 14:07:04
0 2019/12/25 06:13:25
0 2019/12/25 06:13:28
0 2019/12/25 06:13:31
0 2019/12/25 06:15:11
0 2020/01/03 18:40:37
0 2020/01/04 17:14:16
0 2020/01/04 17:14:22
0 2020/01/04 17:14:28
0 2020/01/10 16:01:01
0 2020/01/10 16:01:05
0 2020/01/10 16:01:10
0 2020/02/03 21:51:29
0 2020/02/03 21:51:31
Tearing it down
Tearing it down
0 2020/02/18 17:42:03
Before paint
Before paint
0 2020/02/18 17:42:17
Fresh coat
Fresh coat
0 2020/02/18 17:42:26
4mm moisten barrier
4mm moisten barrier
0 2020/02/18 17:42:34
New screws for handle on left, old ones on right we’re getting stripped out on the head
New screws for handle on left, old ones on right we’re getting stripped out on the head
0 2020/02/18 17:42:42
The old washer vs the new
The old washer vs the new
0 2020/02/18 17:42:49