1st GEN rear bumper and plastic corners and sides
#1
1st GEN rear bumper and plastic corners and sides
I recentlly added a Marlin Crawler bumper https://www.yotatech.com/forums/show...=1#post1025900 to my runner so I no longer need these. The bumper can be seen in the thread about the new bumper but I can put new ones in this thread if needed.
Again these are for a first Gen 4Runner, cam off an 87 DLX to be specific. The color is grey, NOT stock paint had it painted with the runner this year. It's a bit lighter that the stock 87 paint, but it's close. Was painted stock prior to being repainted.
I am asking $75+ actual shipping for the whole thing bumper + all plastic. rear plastic is impossible to get on ebay.
I will accept paypal or check no cash or money orders unless in person.
I'm legit check me out on eBay same user name as yotatech.
Pickup can be in San Diego until this weekend (4th) then will be in Kingman AZ.
contact me via PM for any more info
Again these are for a first Gen 4Runner, cam off an 87 DLX to be specific. The color is grey, NOT stock paint had it painted with the runner this year. It's a bit lighter that the stock 87 paint, but it's close. Was painted stock prior to being repainted.
I am asking $75+ actual shipping for the whole thing bumper + all plastic. rear plastic is impossible to get on ebay.
I will accept paypal or check no cash or money orders unless in person.
I'm legit check me out on eBay same user name as yotatech.
Pickup can be in San Diego until this weekend (4th) then will be in Kingman AZ.
contact me via PM for any more info
#2
Would you consider selling just the 2 plastic body panels that extend from the rear wheel wells back?
Thread
Thread Starter
Forum
Replies
Last Post
voiddweller
86-95 Trucks & 4Runners (Build-Up Section)
19
May 2, 2016 09:10 PM
dirtrider0129
Buying & Selling Advice - Feeler/Gauging Interest
10
Jun 24, 2015 12:24 PM



