I have the rare blue one for sale from a 2nd gen Hilux Surf (4Runner).


Link to my auction: http://cgi.ebay.com/ebaymotors/ws/eB...tem=4612793882


Thanks again,


Chris in Japan

 

Buy it now??

 

I am just going to leave it on Ebay unless there is a good buy it now offer, then I could close it and sell right away.

LMK,

chris

 

14 Hours left on this baby, it is the blue one which I get a lot of pm's for - it is extremely hard to find the blue interior Hilux Surf (4Runner) here in Japan.

Grab it up.

 

Do you have any in gray Chirs?

 

I have just what the Doctor ordered.

Link to the gray Inclinometer: http://cgi.ebay.com/ebaymotors/ws/eB...tem=4614686086





Thank you guys,

Chris in Nippon

 

Great! It has been added to my watch list!

 

Doc, Hope you win this - amazing 4runner option that was not ever available for the 2nd gen stateside.

Ganbatte,

Chris

 

Me too!! I was watching the blue one you had that ended tonight. I was amazed at the condition it was in. I know you are, but I'm hoping the gray one doesn't get to $123 too.

 

do you have any write ups on how to install them... they look awsome but i dont know how to go about installing them

 

I have seen some write ups online and have had cusdtomers email pics of installed ones. I have not saved any of that, these units sell themselves - I am keeping a few for myself when I head back to the states.

Doc, They do go up fast, the last guy was smart - he waited till the last 30 seconds and just threw in a huge bid, locking it in.

 

Installing one is pretty easy it's just two bolts thru the dash, and a wire for the lights. the hard part was getting around the glove box and everything thats behind the dash there, that is if you want to put it where it looks stock. I remember removing the glove box and pulling out the ABS sensor box thingy to reach but everything went back in just as it was with little to no problems. Also, a little bit of trimming was required on the inclinometer where it meets the dash to make it sit right as they are made for right hand drive vehicles, very simple to do.

 

That is the exact opposite of how I remove them!!!

Take out that glove box for access to under the dash, remove the 10mm bolt which holds the abs sensor to the dash, etc, etc

Only thing is I do not drill holes - because well they are there already.

 

this Inclinometer from Japan is still on auction, have a look.

Link to the auction: http://cgi.ebay.com/ebaymotors/ws/eB...tem=4614686086


Thank you,

Chris in Japan

 

Bump for a nice inclinometer.
I purchased the same one, and installation was the same as listed above by OicnaiC.

Here is some photos of mine:

 

THANKS SCOFCO!!!!

Pro job on the install, yours looks great.