whats the cheapest place to buy a TJM-15 for my 98 4runner, or should I go with an ARB? Do you have to fabricate with the TJM-15 or is that the issue only with the ARB bar?

 

mike @ extreme offroad ..

 

I have been searching this pretty extensively.
Best I have found so far was Mikes Group buy... but that is over
Now the best I have seen is Rubicon 4x4 and that is only if you use the discount code given on the Pirate 4x4 board. There is a place to enter the code on checkout and it is PIR31704. That gets you 10% off. Total with shipping is something like $726.00

I wish I had bought during the group buy, but I did not have the funds at the time. I would have saved much over the price above....

Anyone with a better offer let me know too, I am getting close to pulling the trigger on this Bumper!!

 

I don't know if he is still doing the discount price or not, but Mike has price matching with a 10% price match so he could get you the same deal and personally I'd go through mike. Then again... I buy all my stuff from mike. Seriously... give him a gingle and see what he says. If his price is higher, tell him about the other one and he will beat it. But, his prices are usually the lowest... i have found.

 

Not sure if you want a blem one.
The TJM blem sale has pretty low prices on TJM's: http://www.tjmbullbars.com/sale.htm

Toyota 98-00 Tacoma T15 Steel S1587U $549.01
Toyota 99+ 4 Runner T13 Steel S1386W $549.01
I am not sure how much shipping is on them.

 

No TJM-15's for 3rd Gens there though...

 

i paid 500 shipped to my door from rubicon4x4 for my T-17. is the T-15 that much more expensive?

-Casey

 

yup... my T15 was 660 Shipped to my work in the group buy price.

Yeah, they are out of the blem ones for tacos too, my buddy was looking into one.

 

Mike will match 4x4 conections prices ..

 

the ARB bullbars are on ebay for $695 shipped, is that a good deal?

 

Is it true that if you have a body lift and one of these (TJM or ARB) bumpers it will sit low and have a gap between the body and bumper? Ive seen this a few times and think it looks bad, which deters me from buying these bumpers. How do you get around this problem?