I just did the marlin crawler heavy duty seat and bushing install, but a few weeks later I went to disassemble again and when I tried to remove the shifter, the bushing is now stuck in the turret. I tried everything to get it out. It spins freely and can move up and down about a half inch, but gets stuck near the top somehow, maybe there’s a small lip or something. I ended up reinstalling the shifter, but I dont think it is fully seated into the bushing. Anyone else run into this issue or have any tips on how to remove? I tried some simple hooks but they weren’t strong enough and bent. The bushing is too small for most bearing pullers as well.