ABS pump not priming after brake job
Oct 5, 2020 | 07:54 AM
#1
Thread Starter
Registered User
Joined: Oct 2020
Posts: 3
Likes: 0
From: Alberta, Canada
ABS pump not priming after brake job
2000 4Runner 3.4L. Replaced all 4 brakes, calipers & master cylinder. Bled all. ABS pump isn't priming. ABS isn't throwing any codes.
All I get is 3 clicks coming from ABS actuator area when key is in ON position.
I did not use an ABS bleeding tool...could this be the issue? I'm hoping the actuator/pump isn't gone.
All I get is 3 clicks coming from ABS actuator area when key is in ON position.
I did not use an ABS bleeding tool...could this be the issue? I'm hoping the actuator/pump isn't gone.
Thread
Thread Starter
Forum
Replies
Last Post
AppleJack
03+ 4Runner/GX470, & 05+ Tacomas
10
Oct 12, 2007 04:59 PM
