1995 4runner automatic v6

I'm doing a tranny swap since my old one had a c3 clutch in the transfercase get stuck open

Anyways, I noticed the shifter knob had no clicking on the transfercase shifter so I pulled the pan off to see what was wrong

1995 fo

any ideas on how to repair?

 

-Remove valve body
-Remove spacer on the lever shaft using a chisel. (This is on the same side as the PNP switch, but on the inside of transmission)
-After you remove spacer, you will see a locking cylinder on the shaft. Drive out the pin and shaft will then slide out the side of transfer case.

Order a new shaft seal and spacer along with your new Manual Valve Lever.