Manual tranny wiring
Apr 1, 2016 | 02:01 PM
#1
Thread Starter
Registered User
Joined: Mar 2016
Posts: 7
Likes: 0
Manual tranny wiring
I swapped a 98 5spd 3.4 into a 93 T100 5spd.
The 98 did not use a VSS, so I have to run those wires. Why not just run that part of the 93 harness to all the trans plugs and VSS and then just strip the 98 harness down to the 2 O2 sensors and run it? Looking at the diagrams it would seem that there would even be a few less solder joints.
The 98 did not use a VSS, so I have to run those wires. Why not just run that part of the 93 harness to all the trans plugs and VSS and then just strip the 98 harness down to the 2 O2 sensors and run it? Looking at the diagrams it would seem that there would even be a few less solder joints.
Last edited by cat100; Apr 1, 2016 at 04:30 PM.
Thread
Thread Starter
Forum
Replies
Last Post
shredwhiteandblue
93-98 T100s
2
Mar 30, 2016 06:25 PM
nekchris
General Electrical & Lighting Related Topics
2
Mar 14, 2016 11:57 PM
