Intended victim is a 1995 2wd 4Runner, stock. Its sagging on the driver's side and showing some tire wear on the edge of that tire. I'm sagging about 3/4" out of whack and I can visibly see the camber on that wheel isn't right. So I plan to do torsion bar first and see if that corrects the camber. If not, then I'll do that too.

Been reading on here the past two days to bone up on this because I've never made such adjustments. I saw a post where the part numbers were listed but can't seem to find it again. Would like to have one/two on hand since snapping off seems to be a common problem

I need to mail order these from somewhere since we don't have a decent parts house here - much less a dealership. Any recommendations there would be helpful also.

Thanks!

 

Never mind. Got it covered. Thanks!

 

And just what did you find? The whole point of YotaTech is sharing information.