Well I got a little lazy when i was disassembling for a rebuild and wanted to make sure everything goes back where its suppose to.
My questions are...

1. Are the motor mount bolts that attach to the block all the same size...I feel like one bolt on the drivers side was longer than the other 2 bolts. Can anyone confirm this.

2. Also the same question for the bellhousing...?

Does anyone have a list of bolt sizes for reassembly that would be excellent source and if not maybe that will be my contribution to yotatech!!?!?

Thanks for any help guys!

 

Its hard to remember which bolt was where, longer ones wer at the top half.. I remember they were the more difficult ones to get to. Regardless, start with installing long ones.. if they dont go in all the way then they dont belong in that hole.

 

You can check the depth of the holes with a small screwdriver.

 

Thanks guys, nothing common about common sense huh ahaha.