Airlift Kit - Full Kit with Load Controller - 3rd Gen Runner - EA WA
#1
EDIT: Just pay the SHIPPING! Flat $20? I'm about to just toss it in the trash which seems like a waste. If somebody wants to pay the ride its theirs. I figure shipping will run $15-$25 so call it an even $20 and its yours!
Doing some garage cleaning and found a used Airlift kit I bought 5 years ago for my now sold '99 4Runner. Kit looks to have everything in tact, except for the air hose being snipped just above both air bags for removal from PO.
Comes with bags, compressor, air gauge, auto pressure sensor to keep it full, exhaust shields, instructions, wiring, hoses, etc.
I did hook the compressor up to a battery for a couple minutes and verified it works fine but I never fully installed the kit myslef, again it was used by a Yotatech member probably 6 years ago and in my garage ever since.
I'm in Spokane, WA if anybody is local.
I'm over on ih8mud these days so it's best to email me at shanefuller 'at' comcast 'dot' net.
Thanks!
Doing some garage cleaning and found a used Airlift kit I bought 5 years ago for my now sold '99 4Runner. Kit looks to have everything in tact, except for the air hose being snipped just above both air bags for removal from PO.
Comes with bags, compressor, air gauge, auto pressure sensor to keep it full, exhaust shields, instructions, wiring, hoses, etc.
I did hook the compressor up to a battery for a couple minutes and verified it works fine but I never fully installed the kit myslef, again it was used by a Yotatech member probably 6 years ago and in my garage ever since.
I'm in Spokane, WA if anybody is local.
I'm over on ih8mud these days so it's best to email me at shanefuller 'at' comcast 'dot' net.
Thanks!
Last edited by yoda-g2; Apr 17, 2014 at 07:29 AM.
#4
Lol, yes it could help saggy a$$, and I do take paypal.
I would imagine yes. There is only about 3-4" inches hanging off of the bag, but I have no idea where PO mounted it so that would affect how much slack you could work back. It also T's off near the back, so even if you were a little short, you'd only need to run a longer from near teh rear diff outward. (If that makes sense...)
I would imagine yes. There is only about 3-4" inches hanging off of the bag, but I have no idea where PO mounted it so that would affect how much slack you could work back. It also T's off near the back, so even if you were a little short, you'd only need to run a longer from near teh rear diff outward. (If that makes sense...)
Trending Topics
Thread
Thread Starter
Forum
Replies
Last Post
FS[SouthCent]: 03-09 4th G 4runner, GX470, FJ Cruiser front Upper Control Arm Ball Joints Sankei 555
ranma21
Axles - Suspensions - Tires - Wheels
0
Jun 22, 2015 11:55 AM
infinityisfive
Other Makes Cars/Trucks
0
Jun 16, 2015 06:51 PM



