calculate my pinion angles with measurements i made??
Feb 1, 2013 | 10:05 AM
#1
Thread Starter
Registered User
Joined: May 2008
Posts: 300
Likes: 0
From: Fresno, Calif
calculate my pinion angles with measurements i made??
Help me calculate my pinion angles? I have some measurements done with a carpenter’s tool and very unsure what shim degree to get.
"REAR CV DRIVE-LINE"
DL measure from flange to flange = 39”
Measurements from:
TC (transfer-case) = 6*
DL (drive-line) = 22*
Pinion = 71* -- converted ( 90*- 71* = 19* )
My calculations: 22* - 19* = 3*
“3* shim” is needed to tilt the pinion up to align with DL.
Are my calculations correct? Should i consider cruise throttle angle? If so, what is the angle at cruise throttle?
"REAR CV DRIVE-LINE"
DL measure from flange to flange = 39”
Measurements from:
TC (transfer-case) = 6*
DL (drive-line) = 22*
Pinion = 71* -- converted ( 90*- 71* = 19* )
My calculations: 22* - 19* = 3*
“3* shim” is needed to tilt the pinion up to align with DL.
Are my calculations correct? Should i consider cruise throttle angle? If so, what is the angle at cruise throttle?
Last edited by tyes; Feb 1, 2013 at 04:58 PM.
Thread
Thread Starter
Forum
Replies
Last Post
foampile
03+ 4Runner/GX470, & 05+ Tacomas
1
Dec 18, 2022 01:29 PM
Jcrawl94
84-85 Trucks & 4Runners (Build-Up Section)
10
Oct 24, 2015 04:34 PM
trailgoat
86-95 Trucks & 4Runners
3
Aug 13, 2015 05:54 PM
kirkrunner
86-95 Trucks & 4Runners
2
Jul 27, 2015 07:59 PM
