Hey folks, I just installed the fabtech adjustable 0-3.5'' coil overs in the front of my 99 runner. I have a set of OME 906s for the rear that im going with. My overall plan is too have the front too set 3'' above stock, but from what i got reading the 906's will only give me 2'' of lift in the rear and im worried that with them in, it would have too much front rake. So my question is should i go pick up a set of 1" rear coil spacers to set the front and back at a level lift height before i install the real coils? or just install the 906s and set the front 1" higher than the back?

Thanks fellas!

 

Install and go from there. Then adjust front if necessary.

:wabbit2:

 

thanks thats what i ended up doing in the end sets good now but i never ended up setting the front up to quite 3''