i have a 80 yota lifted 4 or 5 inches and if i got a 2 inch body lift could i fit 36x13.5 iroks

 

Kind of hard to tell without a pic, but from your description I would say yes. They should probably easily fit. Might rub on your springs though depending on the backspacing of your wheels.

 

I had a 1980 with a 4" susp. lift and a 3" body lift and ran 38X14.50's on 10" wheels with no problems.

 

ok sweeti can get wheel spacers for cheep if i have to

 

You should be fine then

 

Fit yes.

Replace lots of birfs if you don't have upgraded axles. Yes.

Call folks "sweeti" on an offroad forum while asking a newb question like this

:wabbit2:

 

i ment sweet

 

i ment sweet i can get them for cheep

 

no problem sweeti...

 

yea ok

 

you are gonna want 5.29's

 

i already have the on it

 

I'm going to say you will probably need spacers or really wide wheels with quite an offset I just put some 35x14.50 boggers on my brothers 82 and no way would they work without spacers and I did a RUF so the axle was pushed a few inches forward.

 

Huh? you already have 5.29's?

if you still have the L43, it will hate the 36's

 

yes i already have 5:29s in it

 

whats the L43?

 

the L43 is the side shifting 4 speed that was found in 79-80's, I had one last me a short time running 35's...if you can find a w-56 5 speed you would be better off strength wise...

 

i already have the 5 speed swap aswell

 

Is the trans about 21" long? than you have an L-52, find a spare...

 

no its 15 in