i havent been able to call fabtech for this question its just killin me not knowin but dose anyone know if the bottom spherical ball and urethane mounting end is replaceable on the end of the shock that attaches to the A arm? i have play in it and wouldnt pass inspection

 

Not too sure about the fab tech design but if there are snap rings on either side of the pivot ball than it will most likely come out easily. Although, if there are no snaprings in sight, they most likely either superheated the eyelet to drop the pivot in place, or they pressed the pivot in like a cartage assembly hydraulicly. It has to be able to come out, afterall it was installed in there somehow, it's just a matter of how much force you'll have to apply.