Replacing tranny tailshaft seal, how hard?
May 9, 2011 | 07:00 PM
#1
Thread Starter
Registered User
Joined: Jan 2011
Posts: 41
Likes: 0
From: Nashville
Replacing tranny tailshaft seal, how hard?
Discovered my oil leak is actually gear oil coming out of the back of the tranny where the driveshaft goes in. Truck is a 1993 2wd, 22RE, 5 speed manual.
How hard is this to change out? I'm assuming I can get to it without dropping the tranny out of the truck. Any special tools or pullers needed?
How hard is this to change out? I'm assuming I can get to it without dropping the tranny out of the truck. Any special tools or pullers needed?
May 9, 2011 | 07:15 PM
#2
Registered User
Joined: Dec 2010
Posts: 1,295
Likes: 1
From: tacoma wa
if i remember correctly the yoke is a slip in one and it is not too hard, when i had to do one i just used a screw driver and hammer to get it out and just tap it in with a hammer, u could loose a little fluid but not too much,
Thread
Thread Starter
Forum
Replies
Last Post
Jnkml
95.5-2004 Tacomas & 96-2002 4Runners
3
Jul 6, 2015 01:20 PM
FS[SouthEast]: 1st Gen 4Runner Slider Window, Driver Side
coryc85
Misc Stuff (Vehicle Related)
0
Jul 6, 2015 04:07 AM
