Notices
86-95 Trucks & 4Runners 2nd/3rd gen pickups, and 1st/2nd gen 4Runners with IFS

A/T overdive kick in and out

Thread Tools
 
Search this Thread
 
Old Dec 31, 2009 | 01:38 PM
  #1  
tiller787's Avatar
Thread Starter
Registered User
 
Joined: Sep 2009
Posts: 4
Likes: 0
From: Forest,ont, Canada
A/T overdive kick in and out

Well boys i have surched on the forums for many days now and i can not find what is wrong with my toy. Fist timer treader too.

94 4runner, 3.0l, 340h tany
trany shifts good through 1,2 but sticks before it shifts into overdrive.
It will only kick into overdrive if i play with the peddle. after playing with the peddle it will kick down to 2500rpm then back up to 3000rpm, then out of nowhere it will down shift and hit 4000rpm @ 60mph still.
I also have the problem with it not wanting to go any faster then 65, it will go a little faster with my foot on the ground but it takes minutes for the speed to go up by a mile.

i just did the head gasket, and put a new termo(180), cap, rotor,plugs,wires,

I have checked the linkage, replaced the tempature sencure, looked over all the grounds and bad wires, dumped the fuild and changed the filter.

thank you for your help, i am at a standstill.
Reply
Old Dec 31, 2009 | 01:58 PM
  #2  
rustypigeon's Avatar
Registered User
 
Joined: Jul 2006
Posts: 617
Likes: 4
From: PA USA
Check the TPS.
Reply
Old Dec 31, 2009 | 03:06 PM
  #3  
tiller787's Avatar
Thread Starter
Registered User
 
Joined: Sep 2009
Posts: 4
Likes: 0
From: Forest,ont, Canada
just checked the tps and it is ok, all the right numbers.

i am also going though alot of gas, 1/4 tank is gone after 15 min of driving.
Reply
Old Dec 31, 2009 | 03:22 PM
  #4  
4runnerx3's Avatar
Registered User
 
Joined: Jul 2006
Posts: 922
Likes: 6
From: North Carolina
Maybe you have the throttle cables out of adjustment after the head gasket job. One cable goes to the tranny.
Reply
Old Dec 31, 2009 | 10:57 PM
  #5  
tiller787's Avatar
Thread Starter
Registered User
 
Joined: Sep 2009
Posts: 4
Likes: 0
From: Forest,ont, Canada
the cable to the tany is right, no codes are poping up on the computer or the cruse control computer, unpluged the cruse computer and it did nothing, pulled the o2 out and is not a plugged cat, dumped the oil in the transfer case,

could a speed senser be a problem? I tried to test it with a multi meter and a 12 v power, while spinning the grear but i didnt see the meter move at all. Could it be sending bad signals to the computer?
Reply
Old Dec 31, 2009 | 11:26 PM
  #6  
toyota4x4907's Avatar
Registered User
 
Joined: Sep 2008
Posts: 4,355
Likes: 2
From: middle of no where Alaska
Isn't the OD activated by coolant temperature on the A340Hs? Maybe you need to burp the cooling system more, and/or put in a hotter thermostat.
Reply
Old Jan 1, 2010 | 12:03 AM
  #7  
STEVE_R's Avatar
Registered User
 
Joined: Jul 2008
Posts: 69
Likes: 0
From: backus,MN
you know, i had the exact same problem, i changed the thermostat, and tranny solenoids, and it works just fine now. i got a complete kit that included all solenoids and tranny filter/gasket for a little under $200 from a website, but i dont remember where.
Reply
Old Jan 1, 2010 | 12:05 AM
  #8  
STEVE_R's Avatar
Registered User
 
Joined: Jul 2008
Posts: 69
Likes: 0
From: backus,MN
scratch the "under $200, just over. i got a link from toyota4X4,com? i belive scotty on here runs the site. i could be wrong
Reply
Old Jan 1, 2010 | 08:08 AM
  #9  
ScottyC's Avatar
Registered User
iTrader: (1)
 
Joined: Aug 2006
Posts: 3,477
Likes: 0
From: Ft Collins, CO
Its been a few years since I did the write-up, but here you go:
http://www.toyotaholics.com/support/...sp?TOPIC_ID=19
Reply
Old Jan 1, 2010 | 09:57 AM
  #10  
tiller787's Avatar
Thread Starter
Registered User
 
Joined: Sep 2009
Posts: 4
Likes: 0
From: Forest,ont, Canada
okay i have a new thermo coming from toyota, will check the timing again, ill get back as a check this stuff out, thanks
Reply
Old Jan 4, 2010 | 07:05 AM
  #11  
4runnerkucool's Avatar
Registered User
 
Joined: Jan 2010
Posts: 13
Likes: 0
Originally Posted by tiller787
okay i have a new thermo coming from toyota, will check the timing again, ill get back as a check this stuff out, thanks
I had very similiar problem with yours, it was very simple thing:
https://www.yotatech.com/forums/f120.../#post51323760

Last edited by 4runnerkucool; Jan 4, 2010 at 07:07 AM.
Reply
Old Jan 6, 2010 | 09:42 AM
  #12  
ScottyC's Avatar
Registered User
iTrader: (1)
 
Joined: Aug 2006
Posts: 3,477
Likes: 0
From: Ft Collins, CO
Solenoid set of $174
http://www.bulkpart.com/Merchant2/me...roduct_Count=0
Reply
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
runnygirl19
Newbie Tech Section
4
Nov 19, 2015 11:39 PM
rmill05
84-85 Trucks & 4Runners
0
Sep 27, 2015 01:43 PM
JamesDINAN
95.5-2004 Tacomas & 96-2002 4Runners
6
Sep 22, 2015 05:37 AM
runnermedic
95.5-2004 Tacomas & 96-2002 4Runners
13
Sep 21, 2015 05:20 PM
Wardog
86-95 Trucks & 4Runners
5
Sep 6, 2015 07:57 AM




All times are GMT -8. The time now is 06:10 PM.