4l60e swap
Nov 28, 2009 | 06:46 PM
#1
Thread Starter
Registered User
Joined: Nov 2009
Posts: 32
Likes: 0
From: Tacoma WA
4l60e swap
I am transplanting a 4l60e in a older truck and cannot figure out how to wire the range switch.(the switch on the side of th tranny that the shaft sticks threw) I am having trouble finding a wiring diagram. does anyone have a link?
There are two plugs that are on the switch. A four wire plug and a six wire plug. I have the 4 wire one hooked up but the 6 wire one is the problem. One of the wires is a ground and the other 5 go to the fuse box. The five going to the fuse box are the ones I need a diagram for.
There are two plugs that are on the switch. A four wire plug and a six wire plug. I have the 4 wire one hooked up but the 6 wire one is the problem. One of the wires is a ground and the other 5 go to the fuse box. The five going to the fuse box are the ones I need a diagram for.
Nov 28, 2009 | 07:40 PM
#2
Contributing Member
Joined: Dec 2008
Posts: 2,505
Likes: 16
From: San Jose ,Ca
Im finishing up a lt1 swap into a 66 lemans and got the wiring diagrams from this site .
http://lt1conversion.com/
look under tech articles and then wiring schematics its in there. Looks like its the last diagram
good luck
http://lt1conversion.com/
look under tech articles and then wiring schematics its in there. Looks like its the last diagram
good luck
Last edited by RMA; Nov 28, 2009 at 07:42 PM.
Nov 30, 2009 | 10:49 AM
#5
Thread Starter
Registered User
Joined: Nov 2009
Posts: 32
Likes: 0
From: Tacoma WA
I just went out to fnish the wiring. It turns out my switch is wired differently than the one in the diagram!!! Wire colors and switch configuration is different. I didnt know there was more than one switch? has anybody else ran into this. My 4l60e came out of a 1998 S-10.
Any help, please?
Any help, please?
Thread
Thread Starter
Forum
Replies
Last Post
