I'm designing some skid plates and it would be helpful to have a picture to work off of if I get someone to fab up some of the more complicated bits.

So, anyone rolled their truck lately and have a camera? Like this 3rd gen:

 

 

That's a shame, I did the same thing, it sucked. My was relatively low speed, so after a new set of doors, and some minor bodywork to the roof, it was good as new.

Anyone have a more square view of a flipped 4Runner so I could give a better sense of dimensions?

 

Matt I think the best thing to do is just get under there with a tape,paper and pencil.

I am not sure what your trying to make but I just made a crossmember for my 4runner , took it to a shop and had them bend it ($40) then I drilled the holes .

here are a couple pics




I have more pics in my swap thread of this ,