need a pic of a 2nd gen 4Runner underside
#1
Registered User
Thread Starter
need a pic of a 2nd gen 4Runner underside
I'm designing some skid plates and it would be helpful to have a picture to work off of if I get someone to fab up some of the more complicated bits.
So, anyone rolled their truck lately and have a camera? Like this 3rd gen:
So, anyone rolled their truck lately and have a camera? Like this 3rd gen:
#3
Registered User
Thread Starter
That's a shame, I did the same thing, it sucked. My was relatively low speed, so after a new set of doors, and some minor bodywork to the roof, it was good as new.
Anyone have a more square view of a flipped 4Runner so I could give a better sense of dimensions?
Anyone have a more square view of a flipped 4Runner so I could give a better sense of dimensions?
#4
Contributing Member
Matt I think the best thing to do is just get under there with a tape,paper and pencil.
I am not sure what your trying to make but I just made a crossmember for my 4runner , took it to a shop and had them bend it ($40) then I drilled the holes .
here are a couple pics
I have more pics in my swap thread of this ,
I am not sure what your trying to make but I just made a crossmember for my 4runner , took it to a shop and had them bend it ($40) then I drilled the holes .
here are a couple pics
I have more pics in my swap thread of this ,
Last edited by RMA; 08-25-2009 at 09:20 PM.
Thread
Thread Starter
Forum
Replies
Last Post
RedRunner_87
95.5-2004 Tacomas & 96-2002 4Runners (Build-Up Section)
84
06-01-2021 01:51 PM
FS[PacSouthWest]: 2- 8"3rd members:4.88 ratchet lockers,new setup kit, rear axle rebuild kit,diff armor
jerusry
Axles - Suspensions - Tires - Wheels
1
10-19-2015 05:28 PM
Steezy96yota
86-95 Trucks & 4Runners (Build-Up Section)
1
07-06-2015 10:00 AM