looking for any advice on doing an sas parts needed sorces etc

 

Start a search on solid axle swaps also check out the SAS section on this forum.

 

Start here:
http://www.addictedoffroad.com/Yotasuspension.html

 

sorry for being an idiot that cant spell. and not explaining what i was asking. I have done alot of searching already. What i was wondering is if the standered leaf spring swap is the way to go or if a link setup with coil overs would be better. this is my first build and I apreciate the knoledgeof those of you that have done it

 

If it's your first swap, you should probably go with the leafs. Plenty of people have tons of luck with that setup. A linked suspension is far more complicated, as well as expensive. Good luck with your build, welcome to YT, and make sure to post up a build thread when you start your project.

 

Drive to Alabama and Ill show you all about SAS up close.

 

marlincrawler.com or trail-gear.com has pretty much all the stuf you need for the swap. oh yea wabfab is a big vendor to

 

thanx guys didnt know how things worked here when i asked a beaten to death question. Im kinda a slow learner but i will get there haha. thanks again.