A little rust on this t-case...go or no go?
May 11, 2009 | 03:07 PM
#1
Thread Starter
Registered User
Joined: Apr 2008
Posts: 519
Likes: 1
From: Florida
A little rust on this t-case...go or no go?
Looking to buy this t-case from a guy, I don't know how much he's thinking of selling it for but I think I would pay up to $100...
Should I not even mess with it because of the rust? I'm going to put 4.7 gears in so all the bearings you can see from the outside will be replaced, I'm just a little worried that it might be rusted on the inside.
Should I not even mess with it because of the rust? I'm going to put 4.7 gears in so all the bearings you can see from the outside will be replaced, I'm just a little worried that it might be rusted on the inside.
May 11, 2009 | 03:11 PM
#2
Registered User
Joined: Jan 2008
Posts: 341
Likes: 1
From: Loveland, CO
No way! I don't know where you're located, but around here I can find ready to run cases for $75 all day long. I wouldn't touch that. Plus, it looks to be out of a 1st gen pickup which means you'll have to either replace the drive shaft flanges or redrill those drive shaft bolt holes to 10mm.
Thread
Thread Starter
Forum
Replies
Last Post
live4soccer7
84-85 Trucks & 4Runners
3
May 11, 2016 06:52 PM
Brodetski
86-95 Trucks & 4Runners (Build-Up Section)
0
Sep 30, 2015 11:50 PM
hiluxinargentina
86-95 Trucks & 4Runners
0
Sep 30, 2015 11:12 PM
