How do you install a tach in a 1987 Toyota Pickup 2WD carb.? Does anyone have a picture of where to install the wires? or just where do i install the wires and what color are the wires on my truck that i am suppose to install the tach wires to?

 

follow the instructions on the box of the tach you get...

 

sorry to be off topic, but space junk, whered did you get bfg 33x11.50s?

 

gah... typo... they are 32x11.50s... sorry... and i got them from my brother in law...

HE had 33x11.50s... custom ordered at Les Schwab...

 

When I installed my tach, I hooked it up to a green connector that had a rubber boot over it next to the igniter/coil. I installed a flat male electrical connector on the tach wire and plugged it in. I then wrapped it in black tape to keep it from shorting out. There were three other wires coming out of the tach. One was for switched power, one was a ground, and one was for lights.

 

lol i was gettin ready to say.. suz thats the tire i wanted 33 11.50