HOW to install a tach in a 1987 Pickup 2WD
#1
HOW to install a tach in a 1987 Pickup 2WD
How do you install a tach in a 1987 Toyota Pickup 2WD carb.? Does anyone have a picture of where to install the wires? or just where do i install the wires and what color are the wires on my truck that i am suppose to install the tach wires to?
#5
Registered User
When I installed my tach, I hooked it up to a green connector that had a rubber boot over it next to the igniter/coil. I installed a flat male electrical connector on the tach wire and plugged it in. I then wrapped it in black tape to keep it from shorting out. There were three other wires coming out of the tach. One was for switched power, one was a ground, and one was for lights.
#6
Registered User
Thread
Thread Starter
Forum
Replies
Last Post
Regency
General Electrical & Lighting Related Topics
20
01-03-2020 07:43 PM