ok..so got my '80 all back together...started driving it..drove it for about 1 1/2 weeks..then i got hardly no pressure on the clutch peddle...until it gets about 3 or 4 inches from the floor...so i started adjusting my slave cylinder..(i was told by somebody else to do that) and then i got back inside...had goood pressure on the clutch...then all the sudden i had NONE..so i bleed the slave then went back and had good pressure..then it busted the seal inside the slave...so...wtf...i replaced the slave...and NOW it's just like before..no pressure until almost all the way to the floor...but it only work if i take the spring off of the clutch fork...if the spring is on there....it wont work...i thought i might have a leak...but its not leaking...anybody got any advice??

 

bump...

 

damn...where's all the first gen tech people...

 

did you put an aftermarket clutch in there?

 

is the pedal adjusted properly?

 

What kind of shape is your clutch Master in? Sometimes the seal around the shaft that the pedal pushes leaks and lets air in/fluid out. Besides that just play around with your pedal setup if your sure its bled good.

 

im pretty sure the peddle is adjusted properly...theres a mechanic coming by the house sometime to do the headgasket for the '86 yota 4x4....i'll have him take a look at that peddle to check it all out...thanks again guys...