Put in a new 22R, have some leftover ground wires...
Apr 3, 2008 | 06:35 PM
#1
Thread Starter
Registered User
Joined: Apr 2008
Posts: 15
Likes: 0
Put in a new 22R, have some leftover ground wires...
If anyone can take a quick look and tell me where these are supposed to go I would greatly appreciate it 
Truck is a carbed 86 4x4
This is right between the two heater hoses
Near the header
Truck is a carbed 86 4x4
This is right between the two heater hoses
Near the header
Apr 3, 2008 | 07:39 PM
#2
Registered User
Joined: Sep 2005
Posts: 8,656
Likes: 16
From: NW Ark on wooded ten acres...Ozarks at large!
The top one usually connected to the head and the bottom on the block. But, just connect them...really...to wherever they'll reach on the engine to whatever bolt....just not the valve cover. It's seperated from the head/engine by the rubber gasket....no ground. Those grounds are just to absorb stray currents you may have. They are important, though.
Apr 3, 2008 | 08:33 PM
#3
Registered User
Joined: Jan 2008
Posts: 22
Likes: 0
top one connects to the block/head. I have mine connected on the hook on the right side where u would normally take the motor out with a cherry picker.
the bottom one connects to one of the bolts where the power steering pump bracket connects to the block
the bottom one connects to one of the bolts where the power steering pump bracket connects to the block
Thread
Thread Starter
Forum
Replies
Last Post
the1998sr5
95.5-2004 Tacomas & 96-2002 4Runners
15
Jul 14, 2020 08:35 PM
Sandman
86-95 Trucks & 4Runners
8
Jul 14, 2015 12:36 PM
