Gas gauge not working
#1
Registered User
Thread Starter
Gas gauge not working
Have recently did a holley 500 carb swap on my 87 toyota p/u 22r during the swap i switched over to a electric fuelpump (one that goes outside of the tank) a few months later the pump burnt out so i switched back to the factory mechanical fuel pump and since then my fuel gauge will not do anything i know that i have at least 1/4 tank of gas i have pulled the sending unit and tryed lifting the arm manually and still nothing i have even put a new one in it and still will not read. The gauge worked perfectlly with the electric one and worked before i switched fuel pumps and i am completly stumped any advice would help a bunch
#3
Registered User
Whats been previously stated and to add it maybe the sending unit. In my 87 toyota...the gauge acts funny...i put 1/4 tanks it reads full or sometimes nothing. I haven't played with it. I just keep a gas can in the back of the bed and watch my mileage
#4
Registered User
Thread Starter
Yes the key is on ive eve tested it with the truck running and all of the factory wiring is still being used for it i have not spliced or cut into any of it
Thread
Thread Starter
Forum
Replies
Last Post
Jnkml
95.5-2004 Tacomas & 96-2002 4Runners
3
07-06-2015 01:20 PM
Steezy96yota
86-95 Trucks & 4Runners (Build-Up Section)
1
07-06-2015 10:00 AM