Hi,

I just installed an ACT heavy duty pressure plate and street disk. It replaced an ACT 6 puck race disk...

Anyhow... I had a very difficult time adjusting the clutch pedal and I wonder if anyone else has experienced the same difficulty.

The specific problem is this:

*In order to provide a tiny little bit of through-out bearing to pressure plate gap I need to mash the clutch pedal all the way to the carpet to get enough release to put the thing in gear.

Other than that the clutch works fine.... no slip and very smooth... just much different than the pedal I had with the race disk or stock for that matter.

FYI.... I did bleed the hydraulic system