What size is the nut on the output shaft of the transfer case?
Oct 22, 2007 | 05:12 AM
#1
Thread Starter
Registered User
Joined: Jan 2007
Posts: 365
Likes: 0
From: Cleveland,Tn
What size is the nut on the output shaft of the transfer case?
Well I purchased the All pro tripple X crossmember and E-brake combo.
I thought I could easily have it installed but that was my first mistake.
I thought it would just bolt in,I guess that was an ignorant thought.
I need to take the nut off the out put shaft/flange at the rear of the transfercase so I can install the new disc brake on the drive line. Does anyone know what size it is?I know it is bigger than a 24mm because that is the biggest size socket I own,conveniently
.
Any help would be apreciated,this has been a very frustrating experience,and I feel naked without getting to drive both my 4runners... I need to camp,I need to wheel!
I thought I could easily have it installed but that was my first mistake.
I thought it would just bolt in,I guess that was an ignorant thought.
I need to take the nut off the out put shaft/flange at the rear of the transfercase so I can install the new disc brake on the drive line. Does anyone know what size it is?I know it is bigger than a 24mm because that is the biggest size socket I own,conveniently
.Any help would be apreciated,this has been a very frustrating experience,and I feel naked without getting to drive both my 4runners... I need to camp,I need to wheel!
THANKS! Hopefully I can get something done today!
Thread
Thread Starter
Forum
Replies
Last Post
yourrealdad
95.5-2004 Tacomas & 96-2002 4Runners
3
Jul 29, 2015 11:08 AM
crashburnoveride
86-95 Trucks & 4Runners
1
Jul 10, 2015 06:39 AM
