I have an automatic 95 4runner with a stick for 4wd(ifthat helps). Can I buy Performance Accessories body lift for my truck but for a manual and buy a automatic transmission drop bracket thingy from 4crawler.??????????? and what else do i need?? WHat do you suggest i do???? Thanks a bunch!

 

I would talk to 4crawler and just get it all from him or Wabbit

 

Or make it yourself. UHMW poly rods are cheepm, all you have to do is cut to length and drill for bolts.

 

I personally would talk to 4crawler and buy everything from him.

 

X2, are you sure you need 2 inches of BL? A little BL goes a long way. I sometimes think my 1" is a little too much. How did you get a stick on the auto transfer case, is it a 3.4?

 

If you do a 1"BL,then you don't need to extend any of that stuff. You can fit 33 with some banging of the inner fender..

 

Hey goat i did'nt know if it mattered or not to mention what type of 4x4 selecter i have so i just included it. it sits right next to my automatic trans selector but it does not look like the ones in the manuals like my friends toyota. I'm thinkin 1-1.5 is a better decision now after all the comments thanks. 4Crawler all the way.

 

where could i get a 1 inch body lift for my 93 4runner??

 

Some peoples kids. Didn't you read the post, 4Crawler or Wab Fab for a body lift.

 

I would suggest going with the 1", unless you absolutely need the 2".

The 2" requires quite some extra work besides just inserting the blocks. I had to extend my steering shaft, drop the fan, adjust the front bumper, mess with both shifters, and probably some other stuff that I can't remember. Most of this is not needed if you are doing a 1".

The total process took me about half a day, but 90% of it was adjusting all those other things I just mentioned. A 1" would have probably only taken an hour or two.

And I would also recommend going through 4crawler for everything.

 

where could i get 1 inch body lift for my 93 4runner automatc

 

sorry bro i looked at the wabtech website and didnt see anything

 

i mean wab fab

 

http://www.4crawler.com/4x4/ForSale/BodyLiftKit.shtml
read the page.

 

When I did my 3" on my 89 auto, I had to use the drop bracket for the transmission shifter and I had to lengthen my transfer case lever rod. On the 2" I would assume you would have to do the same.

James