If you wanna see some pics check out my build up thread. I know y'all are pic hounds so I try and post as many as possible. Hopefully I can get your advice and input.

 

Ok like I said the 3 inch TG springs are in, i like the stance, nice n level. I was going to install 6 in shackles in order to rotate my pinion up a bit, but decided against it. I will try some 2 degree shims instead. I will machine a set this week. that pinion needs to come up a bit, we will see.

 

Dang i need 35's

 

Yea thats better........

 

Lookin good man!!!!!

 

^X2, I like the new stance, looks great!

 

NH plate, still holding on strong I see!

 

NH plate, you never know I could go back.

 

6 degree shims in..........I'll snap a few pics as I replace the flexible brake line for a braided longer one.

 

6 degree shims in. Pinion angle better, test drive was positive. No slight off gas growl.

 

Nice! I might need to take another look after moving both axles in the recent past. Got to get those angles right! I love being able to go 90 miles an hour down the freeway and all along the miles per hour there is no shake or shimmy, whatsoever. Anytime I've had some type of wobble, it's usually, probably 90%, from the tires

 

Btw, HOW YOU DOIN? you good?

 

Ya know i'm just dandy, thanks for asking.....And when I get 35's I'll be even dandier.

 

https://www.yotatech.com/forums/imag..._rig.gifig.gif

 

Nothing new to report, rear locker soon at least....

 

 

Teuf! How's things been? Truck's looking sharp as ever!..What kind of locker are you going with?

 

Perhaps a Yukon grizzly or spartan...... depending on funds.....Then I can venture out slowly n wheel some....

 

I just finished the thread. I enjoyed the information everyone shared throughout the build. Nice work. The truck looks good. I'll be watching for the locker update.

 

Oh just weld it! Haha