i have an 87 4runner with dana 60 in back and 44 up front with 35's and the wheels stick out about 2 inches i think i am going to get some fender flares but i don't want to loose any wheel clearance in the back. i would want some cut out flares but i don't know if they make those for the back. Does anybody have any on their vehicles and if so please post some picks.

 

Bushwacker Cutout flares may do the trick, a bit wider than you need, no real cutting in back, a little up front:



or else cut out the rear fenders, fill in the inner wheel well and put on some cut-to-fit rubber flares, which is what I plan to do to replace my old B/W flares.

I have my planned cutting line shown below:

 

sounds good post picks when you do cause that sounds like a good idea