3rd gen 4Runner rear bumper supports
#1
Registered User
Thread Starter
Join Date: May 2007
Location: Denver metro area-CO
Posts: 2,175
Likes: 0
Received 2 Likes
on
2 Posts
3rd gen 4Runner rear bumper supports
Trying once again to give these away . If you were rear ended this should be all the possible pieces you might need to restore as new.
Donor vehicle was a 2000 4Runner- Unsure if it was a Limited or not.
Bumpers are gone.
What remains is all the supporting bracketry for the rear. I have pics- if you need to see them just email.
You would of course pay freight to have the parts shipped-something like $35 from Denver to the East Coast last time I priced it out for taker that fell through. Roughly 27 lbs of parts. Boxed up/ready to go-for two years now.
prefer not to split it all up but if you just need one piece then you could pay a very small fee to have it done that way.
Donor vehicle was a 2000 4Runner- Unsure if it was a Limited or not.
Bumpers are gone.
What remains is all the supporting bracketry for the rear. I have pics- if you need to see them just email.
You would of course pay freight to have the parts shipped-something like $35 from Denver to the East Coast last time I priced it out for taker that fell through. Roughly 27 lbs of parts. Boxed up/ready to go-for two years now.
prefer not to split it all up but if you just need one piece then you could pay a very small fee to have it done that way.
#2
Trying once again to give these away . If you were rear ended this should be all the possible pieces you might need to restore as new.
Donor vehicle was a 2000 4Runner- Unsure if it was a Limited or not.
Bumpers are gone.
What remains is all the supporting bracketry for the rear. I have pics- if you need to see them just email.
You would of course pay freight to have the parts shipped-something like $35 from Denver to the East Coast last time I priced it out for taker that fell through. Roughly 27 lbs of parts. Boxed up/ready to go-for two years now.
prefer not to split it all up but if you just need one piece then you could pay a very small fee to have it done that way.
Donor vehicle was a 2000 4Runner- Unsure if it was a Limited or not.
Bumpers are gone.
What remains is all the supporting bracketry for the rear. I have pics- if you need to see them just email.
You would of course pay freight to have the parts shipped-something like $35 from Denver to the East Coast last time I priced it out for taker that fell through. Roughly 27 lbs of parts. Boxed up/ready to go-for two years now.
prefer not to split it all up but if you just need one piece then you could pay a very small fee to have it done that way.
Thread
Thread Starter
Forum
Replies
Last Post
Team420
95.5-2004 Tacomas & 96-2002 4Runners
4
01-12-2021 04:57 PM
dirtrider0129
Buying & Selling Advice - Feeler/Gauging Interest
10
06-24-2015 12:24 PM