Kmtischer

I am new to this forum and this is my first post. I have a 94 toyota pickup with the V6. I bought it new and have had it ever since. Approximately 5 or 6 years ago I had gone mudding and a few days after my truck starting running like crap. Couldn't figure it out on my own so I took it in. Turned out to be air flow meter wasn't working properly because I sucked in a bunch of mud. They wanted like 800 big ones for a new one. I said can't you just clean it up. They said no, so I said I will clean it myself. Which I did and the truck ran fine again.
HOWEVER, being young and stupid and messed with the spring sprocket. I believe I tightened the spring up maybe 5 teeth. And of course I did not mark the original tooth. really don't remember why I messing with it but I know I Did. so now that I am older and hopefully a little wiser, I would like to put it back to the original tooth. My truck runs fairly well with average gas mileage (15-18). And my truck is stock except for a lift.
So my question is, can someone tell my where the original location is by counting the teeth or posting a picture.
Or should I just leave it??
My next question is , Will aisan locking hubs from an 88 truck fit on my 94 truck??

Cebby

Welcome aboard. Can't help you with the AFM, but yes, the hubs from the 88 will fit your 94 no problemo. It's an easy switch - I did it too.

tomus1000

Cebby already took care of one question, and I don't know the answer to the other one. I can only offer a warm welcome to the best Toyota forum around.

Vato Loco

Welcome to Yotatech