Has anyone seen one of these made for the 3rd gen 4Runner? I found one at Autometer for the Dodge Ram that might work:

http://hp.autometer.com/products/pro...0xx/015002.jpg

Waht do you all think? I see the only problem being the curved 4Runner dash vs. the flat Dodge dash, but a heat gun could be used to mould the pod to conform. I want to put the volt, oil press., and tranny temp up there to clean up my A-pillar.

 

this thread is a bit old but i want to clean up my a-pillar also, therefore i would need a new/used stock a-pillar and a new place to put guages so

BUMP BUMP BUMP BUMP BUMP BUMP BUMP BUMP BUMP BUMP BUMP BUMP
ttt ttt ttt ttt ttt ttt ttt ttt ttt ttt ttt ttt ttt ttt ttt ttt ttt ttt ttt ttt

 

3.4,

Whats wrong w/ your a-pillar mount? i just bought one from gaugepods.com. while *slightly* impairing vision to the left side, nothing that will prevent safe operation.

bob

 

i had a triple gauge pod from a for zx-2 that i got from a buddy. i molded that onto my stock pillar so i had to make a bunch of holes (screws, wires). i took the pod and guages out today so now im left with a stock pillar with 3 1-inch holes and a bunch of little holes from screws. any idea where to get a new one besides the dealer?

 

ask ranma21. or, you might be able to repair it w/ fiberglass and some putty but i dont think it would look seamless.

bob

 

you could make that dash pod out of fiberglass. if you cant, find a stereo shop that does FG work. they should be able to with ease.