installing the FTC-1 split second box
#1
Registered User
Thread Starter
Join Date: Dec 2005
Location: orange county, ca
Posts: 207
Likes: 0
Received 0 Likes
on
0 Posts
installing the FTC-1 split second box
anyone have any experience installing one of these? All instructions I've seen are kind of vague....on a 98'runner, the ECU is behind the glove box right? take that off, then it's behind the heater duct?
anyone know of a good tuner in orange county, ca?
anyone know of a good tuner in orange county, ca?
#2
Registered User
I have installed one on my 99 and the ECU is behind the glove box. Did you buy it from URD? - If so it should have came with a vehicle specific install sheet that tells you all the wires you need to splice into. If not, you will need a factory service manual to get the right wires / colors and thier functions from. It is a very easy install once you find the correct wires.
Thread
Thread Starter
Forum
Replies
Last Post
BeMiceElf
Misc Stuff (Vehicle Related)
7
10-10-2015 09:40 PM
rushw
General Electrical & Lighting Related Topics
4
07-18-2015 01:46 PM
crashburnoveride
86-95 Trucks & 4Runners
1
07-10-2015 06:39 AM
4runner, box, controller, ftc, ftc1, install, installation, instructions, mounting, sec, sewcond, split, urd, wire, wiring