Cranking those bars
Apr 29, 2003 | 12:02 PM
#1
Thread Starter
Contributing Member
Joined: Feb 2003
Posts: 316
Likes: 0
From: Ireland
Cranking those bars
Hello!
Since i put my manual hubs on, i've wanted to level out the front by cranking my torsion bars. So i got under and turned each bolt six revolutions. Didnt make much difference. Its around 14.5 inches all round including 1" body lift. A couple of questions:
1) Should there be more clearance at the front than the back?
2) If anyone has done this, how many revs did they do and what did theirs settle at?
I measured under my front crossmember and i'm getting 8 inches. Seems rather low. Is it?
Since i put my manual hubs on, i've wanted to level out the front by cranking my torsion bars. So i got under and turned each bolt six revolutions. Didnt make much difference. Its around 14.5 inches all round including 1" body lift. A couple of questions:
1) Should there be more clearance at the front than the back?
2) If anyone has done this, how many revs did they do and what did theirs settle at?
I measured under my front crossmember and i'm getting 8 inches. Seems rather low. Is it?
Thread
Thread Starter
Forum
Replies
Last Post
Blamalam
86-95 Trucks & 4Runners
22
Mar 12, 2022 07:34 AM
89fourrunner
86-95 Trucks & 4Runners
3
Feb 17, 2016 06:52 AM
coffey50
Offroad Tech
17
Jul 28, 2015 10:55 AM
