OK, so they fit! I haven't seen em on another 3rd gen yet so it was a bit of an experiment but on paper they looked to fit.

They are 17x8 BBS RD (came on some Tundras in 20" and FJ's in 17") w/ 4.76 bs and weigh in at 28lbs, I'm running a 265/70 Toyo AT, the whole wheel/tire weighs in at almost 67lbs and is only about 1/2" shorter then my old set up.

My old set up was LC 16x8 w/ 4.5 bs and a 255/85 which weighed only 21lbs! w/ Wild Country AT. The rim/tire weighed in at 65lbs each.

I like the look but may go with 1" spacers and def will paint them black. So far ride and handling are about the same as my old set up, maybe a hair more slugish and softer/nicer...maybe. I did have my old tires aired up to 40psi though to get better mpg's.

Here are a cpl quick phone pics (1" BL in pics).... OME shocks/springs, spacers and paint are next.

Bigger pic...you can see the lip better...


With lift, bigger tire might look better....will start with 1" wheel spacers first:


Ride is real nice, gained 2", pretty happy with it! (Thanks Jason!)

 

hi,

looks good! what's the wheel offset?

 

Thanks....I don't think they're everyone's cup of tea though....
The offset is +5mm.

 

Looks Sharp!

 

Thanks...can't wait to get em black...debating b/t a quick Plasticoat joby or full on sand/paint.....I hate prepping and painting wheels!

 

Id just plasticoat ... did the front shield and wheels on my old car and it lasted a good 2 years with minimal fading if you spray clear over it

 

2yrs is pretty good..... I didn't think it fade so I didn't spray clear over it (already did it yesterday), wonder how long it will hold w/o clear? We'll see.... I would have just painted them but I'm still not a 100% committed to these rims.