BeMiceElf's 95' Pickup Build
#23
Registered User
Join Date: Aug 2010
Location: Washington
Posts: 50
Likes: 0
Received 0 Likes
on
0 Posts
So i was looking on the CBI website and noticed they only carry Swing Down tire carriers, does yours swing to the side of the bed? Also what was your turnaround time when ordering the two bumpers. Thanks
#24
Registered User
Thread Starter
iTrader: (1)
Join Date: Aug 2005
Posts: 483
Likes: 0
Received 0 Likes
on
0 Posts
Its a swing away. I don't think Curly's RaceCars is making bumpers anymore, but from CBI I Just gave the measurements I wanted and they built it for my application. They were selling them as an add on at the time. I don't think they are making anything for our generation trucks yet, as far as a complete bumper goes. It took a couple of weeks to get here.
#27
Registered User
Join Date: Nov 2012
Location: Burlington, VT
Posts: 91
Likes: 0
Received 0 Likes
on
0 Posts
How do you like the progressive add a leafs? I'm looking into a new set of OME leafs but if those worked out for you, then I may try and save some money and get them. Also, they don't seem to make them for the pickup, did you use a Tacoma set? Could you post a picture of them? Thanks!
#28
Registered User
Thread Starter
iTrader: (1)
Join Date: Aug 2005
Posts: 483
Likes: 0
Received 0 Likes
on
0 Posts
I don't have a picture, but yes they are for the Tacoma. They have worked great for me, I really like them. you will probably have to cut off the rear clamps on your springs so they will fit.
They raised the rear about an 1.5"
They raised the rear about an 1.5"
#39
Registered User
Just a question, to fit those 33s on the truck how much lift did you have to put on, or is a lift even necessary. I have 31x10.50 on my truck now but want to put a set of 33x10.50 on my truck.