You have a chance to get the pedal set out? Thanks

 

No I worked on it a little and now I broke my collarbone so its even harder to work on it now. I have time but only one arm ahha

 

Oh my bad, sorry to hear it. Just keep me posted then im not in any hurry. Thanks

 

Thanks, you wanted the ECM too, right?

 

coolant overflow reservoir? 96161

 

$35 shipped?

 

........

 

It turns out i dont need the ecm, just the pedal set. Thanks

 

3.0 ECM $75 shipped

 

do you have the clutch slave and hardlines going to the clutch master?

 

anyone home?

 

would you consider shipping just the trans bellhousning?

 

Sorry I never saw this. Possibly, motor and everything is still in it so I don't know when I could do that.

 

Sorry this didn't pop up in my subscribed. Yes but the hard lines might be junk from rust. Slave is good though.

 

Ok. I'll pass on the hardline and slave. I'll just get a new one.

Do you have the lower bellhousing clutch inspection cover by chance?

 

Probably but I don't even know what that is haha.

 

whenever, no rush. just keep it in mind whenever you happen to pull it
the r150f does not have an inspection cover. but if you need one, marlin has them new:
http://www.marlincrawler.com/transmi...llhousing-plug

 

Not a the rubber plug. I need the plate between the bellhousing and the engine block. Not sure if it is 2 pieces on a 3.0 truck or not, if it is I need the lower piece. (I'm working on a 3.4 swap with a r151f tranny. My donor had an auto with a 2 piece plate)

 

ah, ok.

(that's what i'm collecting parts for, too )

 

I need the connector that plugs onto the Engine Coolant Sensor. That's the two wire one, brown and green are the primary colors. Mine was brittle inside and got damaged. Connector with 4 or 5 inches of pigtail attached would be ideal.
Thanks.