Frame tube design?
03-31-2012, 04:18 PM
#1
Registered User
Thread Starter
Join Date: May 2008
Location: Squamish,B.C.
Posts: 55
Likes: 0
Received 0 Likes
on
0 Posts
Frame tube design?
I picked up an 87 4runner recently..Very soon this vehicle is getting a solid axle swap,Mostly from my sas parts from a previous swap..I am running a Sky front hanger and boomerang shackles.I have bought TG jigs which I have found out to have a really large bore compared to my old Sky Jigs.While they both use the factory size bushing,the outside diameter is different between tubes.
I've had a few options running through my mind. 1.Use the TG jigs and push it as fasr forward as the jig allows. 2. Clearance the frame jig to get the tube closer to the front. 3. Get the Sky jigs/tubes.
Have any of you who have re-used your spring hanger for the next swap ran with the same manufacture's jigs/tubes?
I've had a few options running through my mind. 1.Use the TG jigs and push it as fasr forward as the jig allows. 2. Clearance the frame jig to get the tube closer to the front. 3. Get the Sky jigs/tubes.
Have any of you who have re-used your spring hanger for the next swap ran with the same manufacture's jigs/tubes?
Thread
Thread Starter
Forum
Replies
Last Post
justdifferentials
Just Differentials
1
09-17-2015 06:14 PM
DrZero
General Vehicle Related Topics (Non Year Related)
18
07-24-2015 11:31 PM
