Pitman Arm Position
Oct 22, 2016 | 08:05 PM
#1
Thread Starter
Registered User
Joined: Apr 2016
Posts: 204
Likes: 0
From: British Columbia
Pitman Arm Position
90' 4runner
How do I know it's in the proper position when I am replacing it? I'm rebuilding the front end so the tie rods and everything are out too. Is it just a matter of having the steering wheel centered and putting on the new pitman arm as straight as possible by eye?
How do I know it's in the proper position when I am replacing it? I'm rebuilding the front end so the tie rods and everything are out too. Is it just a matter of having the steering wheel centered and putting on the new pitman arm as straight as possible by eye?
Oct 22, 2016 | 11:25 PM
#2
Thread Starter
Registered User
Joined: Apr 2016
Posts: 204
Likes: 0
From: British Columbia
Apparently there should be marks on the cross shaft and pitman arm to line them up according to the FSM. But what exactly is the cross shaft? The FSM diagram does not list that. Could it be the relay rod?
Last edited by mattyboi; Oct 23, 2016 at 12:04 AM.
