Windshield Trim options
#1
Registered User
Thread Starter
Join Date: Oct 2007
Location: Lexington, SC
Posts: 632
Likes: 0
Received 0 Likes
on
0 Posts
Windshield Trim options
Yesterday i was bored at work, i washanging out by the 4runner and i got to looking at the rust area under the trim on my windsiheld. I pried a little of the corner up popped the corner piece off so i could look at the area. Well I tried to put it back on and noticed that the top trim piece has come off a quarter of the way because of me popping the corner off for inspection. So now i have the top corner not stuck back to the truck and i do not see any clips really to hold it into the frame. So what are my options to get it to stick back. Probably adhesive is best bet but i am wondering if there are any other ways to do this. I also bent my trim a touch Boy i so want to get rid of the setup and go with a rubber windshield gasket, but after reading a thread about it, it seems only a "really" good window guy can get it to work. I am nto sure bout who in my area i can get it done
#2
Registered User
Your windshield frame is probably rusting out. It's likely got holes in it already. Once the rust becomes visible on the outside, you can bet that there's a lot more hidden underneath the trim.
#3
Registered User
Thread Starter
Join Date: Oct 2007
Location: Lexington, SC
Posts: 632
Likes: 0
Received 0 Likes
on
0 Posts
Actually from my inspection it wasnt too bad. But for now i just need to get thetrim back on so i donthave to worry bout it flying off down the road
#4
Contributing Member
iTrader: (3)
You can get new trim retaining clips from Toyota.
I ended up getting rid of all my trim a few years ago:
http://www.4crawler.com/4x4/CheapTri...rim/index.html
I ended up getting rid of all my trim a few years ago:
http://www.4crawler.com/4x4/CheapTri...rim/index.html
Thread
Thread Starter
Forum
Replies
Last Post
kawazx636
The Classifieds GraveYard
34
10-06-2021 03:03 PM
bryan34w
Buying & Selling Advice - Feeler/Gauging Interest
12
09-30-2015 02:50 PM