I bought my 1991 toyota pickup a couple months ago and it had a 3 inch body lift, some ghetto 3 inch blocks in the back and the tbars were cranked to level it out in the front. I put some nice 3 inch blocks in the rear and added a 4 inch bracket lift in the front. (i got the blocks and lift kit from a rolled truck). I also replaced my whole front end with the front end from the rolled truck because my 4 wheel drive was messed up(blown front diff) along with the t bars from the rolled truck because I think mine were worn out.
Any ways I have a 4 inch front bracket suspension lift and 3 inch block in the rear with a 3 inch body lift and every one including me think that it looks like at the most 4 inches of lift.... What are some stock measurements so I can figure out how high it rides? What do you think from the pictures also it got 33 inch wildcat mt's(i measured them and there really only 31 inches... )
http://i22.photobucket.com/albums/b3...myspics094.jpg
http://i22.photobucket.com/albums/b3...myspics095.jpg
http://i22.photobucket.com/albums/b3...myspics093.jpg

 

Um - dude ... how to say this YT friendly ...

You worry too much about measurements.


You don't need anywhere NEAR that much lift for 33's.

Oh, and be saving up for new springs - yours are not long for this world with a 3" block.

 

That looks about right for that amount of lift.

X2 on the rear springs, ditch the blocks man. Blocks suck the big one!

Get some proper 4" lift springs and be done with it.
Time for some 35's