torsion bar torque
#1
Registered User
Thread Starter
Join Date: Mar 2011
Location: B.C
Posts: 57
Likes: 0
Received 0 Likes
on
0 Posts
torsion bar torque
I have read the "look here first" thread, but i am looking for more info on torsion bar lift before I go a head and do this.... any write up/photos comments or advise
#2
Registered User
i think my t bars were cranked up, i had 32:11.50's on my truck at one time, but i have to adjust them since i removed and replaced them during my 3.4 swap. i am going to crank them up to where they are closer to the top out bump stop than the bottom out bump stop. if you crank them up too much you will get a rougher ride not enough and you will bottom out easily. i will measure from fender to top of tire to keep them even. if that answers your question.
#3
Registered User
Join Date: Mar 2010
Location: Peoria, AZ
Posts: 504
Likes: 0
Received 0 Likes
on
0 Posts
#4
Registered User
Thread Starter
Join Date: Mar 2011
Location: B.C
Posts: 57
Likes: 0
Received 0 Likes
on
0 Posts
did a zuk mod last fall and have quit a bit of rake... measurement is 13 inch from front fender to rim... but the cv shaft..? has no angel If any at all.. any one have pics of cv shaft at a Angle that is not extreme...or a good angle.. will be getting bj spacers some time this spring.... just inquiring.... thanks...
Thread
Thread Starter
Forum
Replies
Last Post
choppe777
Axles - Suspensions - Tires - Wheels
5
05-16-2016 08:00 AM
WTB[PacNorWest]: Old Man Emu Torison Bars
A2theK
Axles - Suspensions - Tires - Wheels
2
10-14-2015 07:10 AM