T100 CV shafts in a 1st gen 4runner
#1
Registered User
Thread Starter
Join Date: Feb 2015
Location: Missouri
Posts: 16
Likes: 0
Received 0 Likes
on
0 Posts
T100 CV shafts in a 1st gen 4runner
So i know this has been beaten more than a dead horse but...... If i put these in my runner w/ just a 1" BJ spacer would they bind? I ripped a boot after i installed it so im thinking about upgrading to the 100's but not sure if they would bind or not for being to long?
Thanks
Austin
Thanks
Austin
#3
Registered User
Yeah, pay attention. Longer control arms means you need longer CV axles, hence using the T-100 CVs. BJ spacers need the same length CVs you started with but you end up with ripped boots or worse.
Thread
Thread Starter
Forum
Replies
Last Post
RedRunner_87
95.5-2004 Tacomas & 96-2002 4Runners (Build-Up Section)
84
06-01-2021 01:51 PM
FS[SouthEast]: 1st Gen 4Runner Slider Window, Driver Side
coryc85
Misc Stuff (Vehicle Related)
0
07-06-2015 04:07 AM